#TIS 2000 SOFTWARE FULL#
#TIS 2000 SOFTWARE SOFTWARE#
#TIS 2000 SOFTWARE CODE#

Note: Depending on the model year and the selected model either a reprogramming of the ECU (F0: Engine) or of the TCM (F1: Transmission) can be selected.

For the selection of “Next” the vehicle has to be identified as requested by Tech 2.

If Tech 2 has already stored vehicle data they will be displayed now. In that case, Tech 2 asks you to either use the current data (hold data) or request further information from the ECU (continue).

Select “F1: Service Programming System (SPS)” in the main menu.

Turn ignition to ON without start the engine!!!.

Connect Tech 2 scanner to vehicle. Power on device – “Tech 2” is displayed on the screen, then press “ENTER”.

On ‘Select Diagnostic Tool and Programming Process’ (picture below) screen make the desired selection forĢ) the reprogramming of an ECU that was not exchanged or the replacement/programming of a new ECU

Select the application ‘Service Programming System’ on the TIS 2000 start page.Ĥ.

To register the hardware key select ‘Hardware Key Registration’ in the menu ‘Configuration’. Hardware keys that have already been registered are still valid!

#TIS 2000 SOFTWARE CODE#

Note: The hardware key (HWK) has to be registered prior to working with ‘Service Programming System’. To register a hardware key, the form that is enclosed with the hardware key kit has to be filled in and sent to the address at the top. In case the form is missing, the document is also in the TIS 2000 newsletter (see icon in the TIS 2000 tool bar). At first, the user receives a temporary code until the key is registered on the next TIS 2000 CD. If you need to program Saab ECU, you had to use Saab TIS2000 and USB dongle.

#TIS 2000 SOFTWARE SOFTWARE#

TIS2000 will not work on 2007 up GM, and software must work together with TIS2000 USB key.

Download Tech2 Brochure (5.Here is the step-by-step instruction on programming GM (General Motors) ECUs with Tech2 scanner and SPS (Service Programming System) application in TIS2000.īefore using the SPS, make sure that the Tech 2 scan tool and the pc contain the latest software, the battery of the vehicle is fully charged, only the ignition is on power, and all cables are connected properly. Displays up to 9 vehicle parameters at once.

#TIS 2000 SOFTWARE FULL#

Type III slot available for future expansion.ġ3) Communications: Integral RS232 communication port.ġ4) Screen: 3.8.8 backlit monochrome with full graphics capability: 320,40 pixels. The Vetronix Tech 2 comes with Authentic GM software and provides support for on-board diagnostics on all GM systems 1992 thru 2010.Ĭar model supported: GM/SAAB/OPEL/SUZUKI/ISUZU/HOLDENġ) Authentic GM software in the Tech 2 Flash means the most comprehensive diagnostic software available for late model GM vehicles.Ģ) Support for on-board diagnostics on all GM systems 1992 thru current year.ģ) Removable hardware modules provide insurance against scan tool obsolescence.ĥ) RS232 & RS485 ports provide the avenue to connect future devices to your Tech 2 Flash.Ħ) Ability to capture stored DTCs, Freeze Frame, and Failure Record for later review.ħ) Ability to view the status of vehicle diagnostic tests as they run.Ĩ) Bi-directional The authentic GM 1992-current year software will provide full bi-directional control when performing power train, chassis, and body diagnostics.ġ2) Memory: 32 MB flash type II PCMCIA. The Tech-2 is the same tester GM Technicians use to diagnose GM vehicles.

Tis 2000 software